2007 Arctic Cat Four-Stroke Factory Service Manual, Page 66Get this manual
3Place the cylinder head on surface plate covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the cylinder head in figure eight motionInspect the sealing surface for any indication of high spotsA high spot can be noted by bright metallic finishCorrect any high spots before assembly by continuing to move the cylinder head in figure eight motion until uniform bright metallic finish is attained ! CAUTION
Water or parts-cleaning solvent must be used in conjunction with the wet-or-dry sandpaper or damage to the sealing surface may resultGEN-0030
Measuring Cylinder Head Distortion
4Inspect the cylinder for pitting, scoring, scuffing, warpage, and corrosionIf marks are found, repair the surface using the Ball Hone (pn 0644-290) (see Honing Cylinder in this sub-section)5Place the cylinder on the surface plate covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the cylinder in figure eight motionInspect the sealing surface for any indication of high spotsA high spot can be noted by bright metallic finishCorrect any high spots before assembly by continuing to move the cylinder in figure eight motion until uniform bright metallic finish is attained