2007 Arctic Cat Four-Stroke Factory Service Manual, Page 36Get this manual

2007 Arctic Cat Four-Stroke Factory Service Manual, Page 36

! NOTE: After removing the driven pulley, retrieve the cap screw washer from inside the pulley bore; then account for and remove any alignment washersThese washers must be used during installing 26Remove the starter solenoid connector and starter motor cable
MD1700 AO372

27Remove the two rear engine mount nuts; then remove the two front engine mount cap screws
25Remove the two cap screws securing the starter motor; then remove the starter motor

Back to 2007 Arctic Cat Four-Stroke Factory Service Manual