1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 472Get this manual
CHAPTER SIXTEEN
4Install the retaining snap ring (Figure 40)Make sure the snap ring is fully seated5Spin the wheel and check to be sure the wheel rotates straight and smoothlyIf the wheel wobbles, the bearing may not be installed properly6Spin the wheel and check for smoothness after installingTRACK RemovallInstallation
1Remove the rear suspension as described in this chapter2Remove the driveshaft (Figure 41) as described in Chapter Fourteen3Remove the track4Installation is the reverse of the preceding stepsObserve the following step5When installing the track, orient the track lugs to run in the direction shown in Figure 42