1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 470Get this manual
CHAPTER SIXTEEN
NOTE Coat threads of bolts and nuts that are not self-locking with Loctite 271Reassemble using new self-locking nuts
8Lubricate all bushings with low-temperature grease when assembling9Assemble by reversing the removal procedure
10Tighten bolts to the torques listed in Table 111Secure the limit straps with bolt, two large flat washers and nut (Figure 9)REAR ARM AND LOWER ARM RemovalInstallation Refer to Figure 15 or Figure 16 when performing this procedure1Remove the rear suspension as described in this chapter2Remove the rear shock absorber as described in this chapter3Remove the rear springs as described in this chapter4Remove the pivot bolt(s) (Figure 36) and remove the rear arm (49, Figure 15 or Figure 16)WARNING Do not unbolt any brackets from the slide rails until the original mounting hole location is clearly markedThe mounting locations affect suspension action and machine handlingIf there is any question regarding the correct mounting location of any part of the suspension, contact an Arctic Cat dealer or compare mounting location of similar machinesA poorly handling machine is dangerous