1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 458Get this manual
448 should be installed on the bolt in the order they are removed
CHAPTER SIXTEEN
cInstall the valve and piston, making sure the order of assembly is correctThe seven large slots in the piston (14, Figure 19) must be toward the rod end with the nut (5, Figure 19)
9Tighten the retaining nut (5, Figure 19) to 21-28 N.m (15-21 ftlb torqueDo not overtighten10Replace the seal (6, Figure 19) as follows: aSlide the cap (23, Figure 19) and, if so equipped, the bumper (25, Figure 19) toward the piston, then clamp the piston rod in soft-jawed vise