1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 433Get this manual
FRONT SUSPENSION AND STEERING
aInstall the handlebar, clamp and mounting boltsbPosition the handlebar and tighten the steering clamp bolts (Figure 30) in crisscross pattern to the torque specification in Table 1Make sure the gap between the steering clamp steering column support is equal on all four sidesWARNING
Handlebar RemovaVInstallation If handlebar replacement is required, the hand grips will have to be removed to allow removal of the throttle and brake control housingsIf the steering post will be removed, the handle bar assembly can be separated from the post and set aside without removing the throttle and brake controls1Remove the steering pad assembly2If required, remove the throttle and brake control housings from the handlebar (Figure 28 and Figure 29)3Remove the steering clamp bolts and steering clamps (Figure 30), then remove the handlebar4Install in reverse of the removal procedure, observing the following: