1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 423Get this manual
FRONT SUSPENSION AND STEERING Sway Bar Linkage Adjustment 1Lift and support the snowmobile so that the skis are off the ground2Remove the bolt and nut (12 and 13, Figure 16) from one side3The holes in the arm and ball joint (2 and 11, Figure 16) should remain alignedIf the holes are not aligned, proceed as follows: aMake sure the suspension is not binding or restricted on either sidebLoosen the locknuts (8 and 10, Figure 16) and adjust the length of the linkage until the holes are alignedcMeasure the distance between the ends (7 and 11, Figure 16) for the linkage on both sidesdIf the linkage for one side is much longer than the linkage on the other, check for damageMake sure the arms (2, Figure 16) are aligned on the sway bar