1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 419Get this manual
FRONT SUSPENSION AND STEERING
2Attach the upper and lower anns to the spindle, observing the following: aExcept for models with ball joints, the heads of the bolts should be the same direction as originally installedTighten the bolts to the torque listed in Table 1NOTE If the bolts in substep 2a were not marked before disassembling, check with your dealer or inspect similar machine to determine correct direction ofassemblyAll models are not installed as shown in Figure 9
5Install the ski as described in this chapter6Check ski alignment as described in Chapter ThreeAdjust as necessaryLower Suspension Arm Removalllnstallation
Refer to Figure 1-4 for this procedure1Support the front of the machine so both skis are off the ground2Open the hoodNOTE Bolts should be reinstalled with the heads in the same direction as the manufacturer originally installed themBefore removing the bolts, mark the location of the head with paint or marker to facilitate assembly