1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 394Get this manual
384 4Install the bearing (Figure 20) on the left (engine PTO) end of the driven shaft5Insert the driven shaft through the brake disc hub, engaging the key with the keyway in the hub6Check that the driven shaft is centered, then install the flange plates against the side pan (Figure 12 or Figure 17)Tighten the retaining bolts to the torque listed in Table 27Slide the lock collar toward the bearing, but do not lock it8Apply Scotch Bond Adhesive 4174 to the bearing seating area adjacent to the shaft splines9Install the bearing, seal and flange plate on the dropcase housing sideTighten the flange plate retaining nuts to the torque listed in Table 210Slide the lock collar against the bearing and tum the collar in the direction of rotation (opposite the direction shown in Figure 16) to lock the collar11Tighten the setscrew (Figure 15) in the lock collar