1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 365Get this manual
DRIVE SYSTEM
the torque bracket, tum the movable sheave counterclockwise approximately 120 to tension the springPush down the torque bracket so it bottoms on the buttonsInstall the washer and snap ringNOTE Install the snap ring so the sharp side is out, away from the washer
16To assemble the driven pulley, reverse the disassembly procedure while noting the followmg: aApply Loctite 242 (blue) to all screw threadsbTo properly install the torque bracket (6, Figure 78), first install the key (3, Figure 78)Place the torque bracket on the spring with the outer end of the spring inserted into the middle hole in the camWhile holding
cBe sure alignment marks are aligned
Table DRIVE BELT SPECIFICATIONS Model Part NoWidth mm (in Circumference cm (in
1990 Prowler, EI Tigre EXT 1991-1992 Prowler, Cougar, EITigreEXT 1993 Prowler, Cougar 440ZR EXT 550, EXT 580 580ZR 1994 Cougar, Prowler ZR 440, EXT 580, ZR 580 1995 Cougar, Prowler 2-Up Z440 ZR 440, EXT 580, EXT 580 EFI, ZR 580, ZR 580 EFI