1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 298Get this manual
288 Emergency Kill (Stop) Switch The emergency stop switch (Figure 42) is located in the throttle housingTo replace the switch, disassemble the throttle housingDisconnect the switch connectors and remove the switchReverse to installHeadlight Dimmer Switch The headlight dimmer switch is mounted in the brake lever housingTo replace the switch, unbolt the switch from the brake housingDisconnect the switch connectors and remove the switchReverse to installBrake Light Switch The brake light switch is located in the brake lever housingTo replace the switch, disassemble the brake housingDisconnect the switch connectors and remove the switchReverse the removal procedure to installIgnition Switch The ignition switch is mounted on the consoleDepending upon the ignition type, the switch may stop the ignition by either grounding the ignition circuit or opening the ignition circuitIf the ignition switch is normally open to run, grounding the circuit will stop ignitionIf the ignition switch is normally closed to run, open.ing the circuit will stop the ignitionMake sure the replacement switch is the correct typeTemperature Sensor The temperature sensor (Figure 43, typical) is located in the coolant outlet (thermostat) housingSome models are equipped with an overheat warning light, while others are equipped with gaugeRefer to Chapter Seven to test the unit on