1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 295Get this manual
ELECTRICAL SYSTEM Headlight Replacement (Multiple-bulb Type)
Figure 36 should also be two feet above the floor3Start the engine, tum on the headlight and set the beam selector to HIGHDo not adjust the headlight beam with the selector set on LOW4The center area of the beam on the wall should be in(5 cm) below the mark (Figure 36)5To move the beam, tum the headlight housing adjusting screws (Figure 37)Taillight Bulb Replacement
1Remove the taillight lens mounting screws (Figure 38) and remove the lens2Tum the bulb counterclockwise and remove it3Clean the lens in mild detergent and check for cracks4Installation is the reverse of the preceding steps
If the headlight has just burned out or
turned off it will be hotDo not touch the bulb until it cools off
WARNING
1Open the hood2Disconnect the wire from the headlight bulb base3Rotate the headlight bulb base counterclockwise and remove the bulb4Installation is the reverse of the preceding stepsMake sure the bulb engages the connector fully