1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 291Get this manual
ELECTRICAL SYSTEM
1Remove the flywheel as described in this chapter2If the engine is installed, disconnect the wires from the stator at the electrical connectors3Make mark on the stator plate and crankcase for alignment during reassembly (Figure 23, typical)4Remove the screws (B, Figure 24 or Figure 25) that attach the stator plate to the crankcaseRemove the grommet and pull the wires through the opening while removing the stator plate5Installation is the reverse of the preceding stepsObserve the following: aCheck the coil wires for chafing or other damageReplace the coil harness, if necessarybCheck and adjust ignition timing as described in Chapter ThreecMake sure all electrical connections are tight and free from corrosionLoose or