1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 258Get this manual
CHAPTER SEVEN
1Open the clutch cover and remove the drive belt2Remove the driven pulley (Chapter Fourteen)3Remove the E-ring attaching the control cable to the oil injection pump control leverDo not lose the washer4Loosen the clamp nuts attaching the lower end of the oil injection pump control cable5Separate the control cable from the oil injection pump control lever and the cable housing bracket6Loosen the clamp nuts (Figure 25 or Figure 26) attaching the cable housing to the bracket7Remove the handlebar pad8Remove the ties securing the throttle cable9Detach the cable from the throttle lever10Remove the retaining ring from the upper end of the cable housing, then withdraw the cable from the throttle switch and control assembly11When installing, reverse the removal procedure, observing the following: aRoute the upper end of the cable and housing through the throttle switch and housingbInstall the retaining ring at the upper end of the cable housing and attach the cable to the throttle levercRoute the cable from the handlebar control to the throttle body assembly, being careful that the cable is not kinked and will not interfere with moving partsdAttach the throttle cable to the operating lever of the throttle bodyMake sure the throttle plates will close completelyeRoute the cable to the oil injection pump control lever, then install the washer and E-ringfAdjust the cable by turning clamp nuts (Figure 25 or Figure 26), as necessary, to provide 0.75-1.5 mm (0.030-0.060 in free play between the lever and the bodyTighten clamp nuts securely