1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 252Get this manual
CHAPTER SEVEN
to test the batteryless systems found on 1997 and 1998 models
1Make sure the ignition switch is OFF2Detach the sensor at the black two-wire connector3Use an ohmmeter to measure the resistance between the terminals of the sensorBe sure the wires are greenwhite and brown4The correct resistance is 152-228 ohmsIf the resistance is incorrect, the sensor is faulty5Models prior to 1997-To test the sensor voltage output, attach the diagnostic harness as described in this chapter6Attach voltmeter that will measure low AC volts to pins No10 and No17 (Figure 5) of the diagnostic harness7Crank the engine as hard as possible while observing the voltage output8The voltage should be in the range of 0.1-0.9