1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 183Get this manual
and axial play (Figure 56)If any play exists, the pin and bearing should be replaced, providing the rod bore is in good conditionIf the condition of the rod bore is in question, the old pin and bearing can be checked with new connecting rodbOil the piston pin and install it in the piston pin hole (Figure 57)Check for up and down play between the pin and pistonThere should be no noticeable playIf play is noticeable, replace the piston pin andor piston
ice specification listed in Table 2-9Replace the piston if the piston pin bore diameter is too large5If you do not have access to micrometer and snap gauge to perform Steps and 4, perform the following: aOil the needle bearing and piston pin and install them in the connecting rodSlowly rotate the piston pin and check for radial