1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 161Get this manual
been changed or replaced, label each electrical connection before separating it5Use vise with protective jaws to hold partsIf protective jaws are not available, insert wooden blocks on either side of the parte s) before clamping it in the vise6Remove and install pressed-on parts with an appropriate mandrel, support and hydraulic pressDo not try to pry, hammer or otherwise force them on or off7Refer to Table 10 at the end of the chapter for torque specificationsProper torque is essential
to ensure long life and satisfactory service from snowmobile components8Discard all a-rings and oil seals during disassemblyApply small amount of heat-resistant grease to the inner lips of each oil seal to prevent damage when the engine is first started9Keep record of all shims as they are removedAs soon as the shims are removed, inspect them for damage and write down their thickness and location10Work in an area where there is sufficient lighting and room for component storage