1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 100Get this manual
90 8If the track is closer to the slider shoes on one side, the alignment should be adjusted as follows: aLoosen locknuts (A, Figure 28) on adjusters of both sidesbIf the track is offset to the left, tighten the left adjuster bolt (B, Figure 28) and loosen the right one exactly the same amountcIf the track is offset to the right, tighten the right adjuster bolt (B, Figure 28) and loosen the left one exactly the same amountdRepeat Steps 4, and to recheck alignmentIf alignment is still not correct, repeat substep 8a-8c to adjust, then Steps 4, and until the track is properly aligned9Recheck track tension as described in this chapter after making any changes to the adjuster bolts (B, Figure 28)Electrical Connectors
CHAPTER THREE
Inspect the high-tension electrical leads to the spark plugs (Figure 30) for cracks and breaks in the insulation and replace the leads if they are not perfectBreaks in the insulation allow the spark to arc to ground and will impair engine performanceCheck primary ignition and lighting wiring for damaged insulationUsually minor damage can be repaired by wrapping the damaged area with electrical insulating tapeIf insulation damage is extensive, replace the damaged wires