1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 98Get this manual
CHAPTER THREE
specified in Step 2, replace both wear strips as described in Chapter Sixteen
1Raise the snowmobile with suitable lift so that the track is clear of the ground2Clean ice, snow and dirt from the track and suspension3Attach spring scale to the track at approximately the middle of the slider shoe (Figure 27)Pull the scale to deflect the track away from the slider shoe until force of kg(20 lbs is indicated by the scale4Measure the distance between the slider shoe and the inside of the trackRefer to Table for the recommended deflection5If the measured deflection is incorrect, adjust track tension as follows: aLoosen the locknut (A, Figure 28) on each of the two adjustersOne adjuster is located on the left side and the other adjuster is located on the right sideBe careful not to disturb the setting of the adjuster screw (B, Figure 28)