1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 60Get this manual
50 together until they clickMake sure they are fully engaged and locked together (Figure 8)3Check all electrical components for good ground to the engine4Check all wiring for short circuits or open circuits5Make sure the fuel tank has an adequate supply of fresh gasoline and that the oil tank is properly filled6Check the spark plug cable routing (Figure 9) and be sure the cables are properly connected to the spark plugsCAUTION To prevent expensive engine damage, refer to the Caution under Spark Plug Removal in Chapter Three
CHAPTER TWO
dTurn the ignition switch ON and set the tether and cut-out switches to the ON positioneCrank the engine over with the starterA fat blue spark should be evident across the spark plug electrodefIf there is no spark or only weak one, check for loose connections at the coilIf all external wiring connections are good, check the remaining components of the ignition systemgTurn the ignition switch OFF