1990-1998 Arctic Cat Snowmobiles Repair Manual, Page 38Get this manual
28 5Coat the bottom half of new stud with Loctite 271 (red)6Tum the top nut clockwise and thread the new stud securely7Remove the nuts and repeat for each stud as required8Follow Loctite's directions on cure time before assembling the component
CHAPTER ONE
BALL BEARING REPLACEMENT
Ball bearings (Figure 68) are used throughout the snowmobile engine and chassis to reduce power loss, heat and noise resulting from frictionBecause ball bearings are precision made parts, they must be maintained by proper lubrication and maintenanceReplace damaged bearingsUsing damaged bearing can result in additional damage to an adjacent shaft or caseIf installing new bearing, exercise care to prevent damage to the new bearingWhile bearing replacement is described in the individual chapters where applicable, the following should be used as guidelineNOTE Unless otherwise specified, install bearings with the manufacturer's mark or number facing outward