2008 Yamaha WaveRunner FX SHO / FX Cruiser SHO Service Manual, Page 364Get this manual
HULL HOOD Handlebar
Installation steps: 1Wrap the packings 1, making sure to align the upper edge of the packing with the upper edge of the marking tape on the lead and cableMarking tape b: FX SHO: Throttle cable White QSTS cable White Handlebar switch leads Blue FX Cruiser SHO: Throttle cable Gray QSTS cable Blue Handlebar switch leads Blue 2Install the packing into the grommets and 33Make sure that the edge of the packing is the specified distance from the upper edge of the grommetInstallation distance c: 10 mm (0.39 in) 4Fasten the end of each grommet with the plastic tie 8NOTE: Position the corrugated tube for the throttle cable so that the end of the tube makes contact with the packing as shown