2008 Yamaha WaveRunner FX SHO / FX Cruiser SHO Service Manual, Page 49Get this manual
GEN INFO
Technical tips
No-wake mode control The no-wake mode has been added as new functionThe no-wake mode is function for operating the watercraft at low speed to limit the watercraft's wakeIn this mode, the ECM automatically maintains the engine speed at approximately 2,100 rminWhen the no-wake mode is activated, "5" (when miles are selected) or "8" (when kilometers are selected) starts flashing in the digital speedometer display to inform the rider that the mode has been activatedThe no-wake mode cannot be activated immediately after starting the engineAfter starting the engine, wait for seconds or more before activating the modeTo activate the no-wake mode: Push and hold the "NO-WAKE MODE" switchWhen the no-wake mode is activated, the beeper sounds times quickly and "5" (when miles are selected) or "8" (when kilometers are selected) starts flashing in the digital speedometer displayKeep the throttle lever in the idle position when the no-wake mode is activatedTo deactivate the no-wake mode: Perform one of the following procedures to deactivate the no-wake mode Push the "NO-WAKE MODE" switch Squeeze the throttle lever Move the shift lever to the reverse position Stop the engineThe beeper sounds times quickly and the digital speedometer display stops flashing when the nowake mode is deactivated1 "NO-WAKE MODE" switch Number of beeps No-wake mode operation Activated Deactivated Digital speedometer display Starts flashing Stops flashing