1998-2000 Yamaha WaveRunner GP800 Factory Service Manual, Page 206Get this manual
t! tl_H_U_l_l_ c_r_") 2To prevent water from entering the urethane foam, apply silicone sealant to the inside of the hole as shown3Install the insert nut as explained in "ExampleBrass insert nut CD Hull Urethane foam Silicone sealant
Graphic removal 1Hold hair dryer approximately 1.5 inches above the graphic CD2Apply heat to one corner of the graphic3Slowly peel off the heated portion of the graphic and continue working until you reach the opposite corner and the entire graphic is removed4After the graphic is removed, clean the entire bow area with isopropyl alcohol to remove any residual adhesive-