1994-1997 Yamaha WaveRider Service Manual LIT-18616-RA-00, Page 189Get this manual
Insert nut NOTE: When pop nut clinched to hull slipped off or when bolt fastened to an insert nut or pop nut was broken, use this insert nutPart Name Nut
Part NoEW2-62733-09
19 mm (0.75 in
Remarks Stainless steel, M6
Nut CD Direction of thread Slot to be threaded NOTE: Drilling size Material FRPorSMC Brass Pilot hold diameter 9.19.2 mm (0.36 in) 9.4 mm (0.37 in)
80-100 mm (3-4 in
Example 1: The nut is used to repair the pop nut designed for plate 2(by repairing the FRP portion, the new-type nut can be used for all models) For details of repairs to the FRP portion, refer to the "Water Vehicle FRP Repair Manual"1Remove: Pop nut 2Scarf the shaded portion3Clean the surface to be scarfed and the inside of the hull with acetone4As shown, first tape up the inner surface of the hull and then laminate fiberglass mats over the tape using resinNOTE: _ When it is possible to work inside the hull, the mats should be laminated from the inside