Bombardier SeaDoo 2007 factory shop manual, Page 369Get this manual
Section 09 HULUBODY Subsection 01 (ADJUSTMENT AND REPAIR)
Pull the drain plug and unplug hoseRemove all silicone residues on hull (inside and outside) and in screws holes
For general purpose cleaningt use BRP PlasticVinyl Cleaner (PIN 41 71 200)) Vinyl Finish Vinyl Cleaner) Fantastik or warm water with mild dish soap such as Dawn or Ivory, Gently scrub with small soft bristle brush
Installation
Apply Loctite 51 50 (silicone sealant) (PIN 293 800 086) on back side of drain plug, Plug hose on drain plug and carefully insert drain plug in its holeMake sure the end of drain plug (with small holes) does not touch the siliconeSilicone could block drain holes the end of drain plugInside hullr apply Loctite 51 50 (silicone sealant} {PIN 293 800 086) on the end of screws, Attach elbow fittings the highest position that you can on the exhaust hose
For dirt build-upf use BRP PlasticVinyl Cleaner (PIN 413 71 Vinyl Finish Vinyl Cleaner or an equivalentLet soak for approximately minutes, then gently scrub with soft bristle brushFor specific stain removal, refer to your cleaning and care cardDo not use any silicone-based protectantsThey WIII extract the plasticzers leaving the vinyl hard and brittle) and eventually cracking will occur