Bombardier SeaDoo 2007 factory shop manual, Page 209Get this manual
Section 04 ENGINE MANAGEMENT503 4-TEC) Subsection 03 (ADJUSTMENT AND REPAIR PROCEDURES)
FUEL RAIL ASS'Y 1Fuel tt-lector 2injector chp 30 g
Installation For the installation, reverse the removal procedurePaying attention to the following details
TYPICAI!7Throttle body 2Throttle cable attachment 3Throttle plate 4TPS 5Idle bypass channel 6Idle bypass valve
If you reinstall used injectorr carefully inspect O-ring condition before reinstalling fuel injectorReplace O-ring with new one if damagedlnsert the fuel injector in place with your hand, NOTE: thin film of engine oil should be applied to O-rings to ease insertion in fuel rail and intake manifoldApply Loctite 243 on rail retaining screws then lorque to Nem (89 lbfain)When installing fuel line connector to the fuel railr put some oil on the O-ring to ease installation
The adjustment of the idle stop screw is optimized by the throttle body manufacturer and locked to prevent any modification