Bombardier SeaDoo 2007 factory shop manual, Page 178Get this manual
Section 03 ENGINE Subsection (CYLINDER BLOCK)
Bearings have be flush with the cylinder block split surface and their protrusions have fit in the notched areas in the cylinder block seat
CAUTION: Do not use other products to seal crankcase Do not use an activator with the Loctite 5910Using other products or silicone-based sea la nt over previously sealed crankcase with Loctite 5910 will lead to poor adhesion and possibly leaking crankcaseNOTE: Refer to the product label for sealant curing timeRespect the manufacturer's recommendations prior start engineUse plexiglass plate and apply some sea ant on itUse soft rubber roller (5075 mm (2- in)) (available in arts products suppliers for priing) and roll the sealant to get thin unifor coat on the plate (spread as necessary)When ready, apply the sealant on crankcase maling surfaces
7 Bearing protrusion in cyltnder bockh