Bombardier SeaDoo 2007 factory shop manual, Page 126Get this manual
Section 03 ENGINE Subsection 08 (LUBRICATION SYSTEM)
NOTE: Make sure not to loose thrust washer when removing it from oil separator cover, otherwise thrust washer would fall into the PTO
1 Camshaft 2011 separator cover
1 Thrust washer 201 separator 1
NOTE: Be careful no1 to break the holding clips from oil separator cover when its removed from the timing gear
Inspection
If O-rings and V-rings are brittle, cracked or hard, replace themClean all contact surfaces of oil separator cover and TOPS valveInspect oil separator cover for marks or other damagesEnsure to check also the holding clips of oil separator cover and for thrust washertf any damage is visible replace oil separator cover