Bombardier SeaDoo 2007 factory shop manual, Page 113Get this manual
Section 03 ENGINE Subsection 08 (LUBRtCATION SYSTEM)
MAINTENANCE
OIL LEVEL VERIFICATION
CAUTION: Check level frequently and refill if necessaryDo not overfillit would make the engine smoke and reduce its powerOperating the engine with an level may severely damage engineWipe off any spillage
CAUTION: Failure flush exhaust cooling system, when watercraft is out of water, may severely damage engine andor exhaust system- Warm-up engine then let idle for 30 seconds before stopping- Stop engine- Wait least 30 seconds then pull dipstick out and wipe clean
Engine oil may be hotCertain components in the engine compartment may be very hotDirect contact may result in skin burn
CAUTION: Never run engine longer than minutesDrive line seal has no cooling when watercraft is out of water- Reinstall dipstick, push in completely- Remove dipstick and read oil levelIt should be between marks
Dt,ustck
Check the oil level as follows: NOTE: It is of the utmost importance to follow this procedure in order toaccurate reading of an the engine oil level- Watercraf must be level, Check oil level either with watercraft in water or out of waterEngine should be warm