Bombardier SeaDoo 2007 factory shop manual, Page 108Get this manual
Section 03 ENGINE Subsection 07 (PTO HOUSING AND MAGNETO)
STARTER DRIVE
Removal
Remove:PTO housing and ring gear as described abovestarter drive ass'y nom 8
Installation
For installation, reverse the removal procedureHoweverl pay attentton to the following,
NOTE: When installing new starter drive ass'y, oil the shaft and threads of the gear with engine
oilApply some lsoflex Topas N652 grease (PIN 293 550 02on the starter drive bearing located in the cylinder block and on the starter drive support in the PTO housing cover
TYPICAL
1Starter drivey