Bombardier SeaDoo 2007 factory shop manual, Page 92Get this manual
Section 03 ENGINE Subsection 06 (EXHAUST SYSTEM)
Run the engine about 20 seconds fast idle between 40005000 RPM,
CAUTION: Never run engine longer than minutesDrive line seal has no cooling when watercraft is out of waterEnsure water flows out of jet pump while flushingClose the water tap, then stop the engineCAUTION: Always close the water tap before stopping the engineDisconnect the garden hoseCAUTION: Remove flushing connector adapter after operation (if used)
Remove dust cap from flushing connector and attach coupler hose (supplied with vehicle)Make sure coupler hose is properly locked to flushing con nectoi-Install small hose pincher (PIN 295 000 076) (supplied inside vehicle tool kit) on water outlet hoseThis prevent water from directly existing exhaust cooling system
Procedure Using Flushing Connector in Engine Compartment
GTX Limited Models This flushing connector allows to flush the exhaust systern directly by the engine compartmentThe access is easier than the connector on the jet pump support but requires the use of small hose pncherRemove seat to gain access