Bombardier SeaDoo 2001 factory shop manual, Page 541Get this manual
Section 16 WIRING DIAGRAMS Subsection 01 (WIRING DIAGRAMS)
Contact Installation
For insertion of signal contact, make sure the wedge lock is in the open positionNOTE: For insertion of power contact, the wedge lock may or may not be on the open positionInsert contact into appropriate circuit cavity and push as far as it will goPull back on the contact wire to be sure the retention fingers in the housing are holding the contact properlyAfter all required contacts have been inserted, the wedge lock must be closed to its locked position
F12H10A
1Deutsch joint connector tool (no114010)
MAIN FUSE HOLDER JOINT CONNECTOR
DI Models The fuse holder is located in the rear electrical boxF12H11A
1Hold the insulator 2Push the tool until it bottoms
F12H0ZA