Bombardier SeaDoo 2001 factory shop manual, Page 540Get this manual
Section 16 WIRING DIAGRAMS Subsection 01 (WIRING DIAGRAMS)
Before extraction, push wire forward to relieve pressure on retaining tabInsert 4.8 mm (.189 in) wide screwdriver blade inside the front of the contact cavity
F00B0EA
CRIMPING TOOL (PN 295 100 164)
All circuits are sealed by diaphragm in the rubber wire sealWhen installing wire contacts in plug connector, the diaphragm is pierced as the contact passes through itIf the diaphragm is pierced and the cavity is not used, install seal plug, large end first, into circuit cavity as far as it will goNOTE: It is suggested that all unused circuit cavities be sealed with seal plug, even if they are not pierced.F00H0ZA
Pry back the retaining tab while gently pulling wire back until contact is removed