Bombardier SeaDoo 2001 factory shop manual, Page 539Get this manual
Section 16 WIRING DIAGRAMS Subsection 01 (WIRING DIAGRAMS)
Contact Removal
SIGNAL WIRE Insert screwdriver blade between the connector and the wedge lock tabRelease the locking tab and at the same time, pry open the wedge lock to open positionCAUTION: The wedge lock should never be removed from the connector for insertion or removal of the signal wire contacts1 2
While rotating the wire back and forth over half turn (14 turn in each direction), gently pull the wire until the contact is removed