Bombardier SeaDoo 2001 factory shop manual, Page 506Get this manual
Section 14 HULLBODY Subsection 02 (ADJUSTMENT AND REPAIR)
Ensure that the seat rest firmly against hard surface such as piece of woodThis is done to get the staples completely pushed in place
4Slide bumper rail no4 under front bumper no135Using 4.80 mm (316 in) drill bit, drill first hole through bumper rail no4 at front of bow sectionUse locating mark as guideThen install rivet no12CAUTION: When drilling, be careful not to damage bumper rail andor hull6Position bumper rail no4 properly onto body and cut excess length if necessary7Slide bumper rail no4 in corner bumper no148Using hole positions previously marked on body, drill holes in bumper rail no4 and install rivets no129Install trim no5 using soapy water10Repeat procedure for the other side
SPONSON REPLACEMENTF01L3YA
TYPICAL 1Piece of wood 2ETN-50 (electric) or T-50 (manual)
After cover installation cut all around the excess of material
RX Series Remove retaining screw from rear of sponsonPull sponson outAt installation, apply Loctite 271 (red) on screw threads and on sponson nutTorque screw to Nm (53 lbfin)