Bombardier SeaDoo 2001 factory shop manual, Page 502Get this manual
Section 14 HULLBODY Subsection 02 (ADJUSTMENT AND REPAIR)
JET PUMP SUPPORT
Removal
Remove jet pumpRefer to JET PUMPRemove inlet grate and riding plateRemove ball joint, boot, nut, half rings and O-rings from steering cable
Using heat gun, heat jet pump support until it is possible to pull itNOTE: Shims may have been installed between support and bodyDo not remove these shims, otherwise jet pump alignment will be altered
Installation
Apply Loctite The Right Stuff Gasket as indicated by the shaded areas in the next illustrationsFollow also the torquing sequence as shown in the same illustrations1 2