Bombardier SeaDoo 2001 factory shop manual, Page 438Get this manual
Section 11 PROPULSION SYSTEM Subsection 03 (DRIVE SYSTEM)
Front Drive Shaft Coupler and Damper
Make sure to install dampers into drive shaft coupler at both ends
NOTE: Make sure to install floating ring before inserting the drive shaft in the PTO flywheelWhile holding jet pump, guide and engage drive shaft splines in PTO flywheelRotate shaft to properly index splinesMake sure boot is well positioned over shaft endAll Models
Circlip
Push the floating ring to compress the bootInsert the circlip no5 in the drive shaft groove1 2
F08I07A
SAME COUPLER AND DAMPER AT BOTH ENDS 1Damper 2Drive shaft coupler
Front Drive Shaft
Install front drive shaft no20
Rear Drive Shaft
Install damper no13 to rear drive shaft no12Install drive shaft and jet pump at the same timeInsert drive shaft through carbon ring no8 and floating ring no6Insert drive shaft through seal carrier no14 and into the coupler assemblyBe careful not to damage sealsCAUTION: When sliding the drive shaft through seal carrier, the double lip seal can be folded overThis would cause seal carrier bearing failureReinstall protective plate no18Apply Loctite 243 (blue) on bolts and torque lock nuts to 10 Nm (88 lbfin)All Models except XP