Bombardier SeaDoo 2001 factory shop manual, Page 437Get this manual
Section 11 PROPULSION SYSTEM Subsection 03 (DRIVE SYSTEM)
INSTALLATION
Installation is essentially the reverse of removal procedureHowever, pay particular attention to the followingXP Models
Carefully slide shaft through support plate and seal carrierInsert adapter end into PTO flywheelNOTE: Ensure the mid bearing is loosened
Seal Carrier of Mid Bearing
Properly index flanges no22 togetherInstall seal carrier and hand tighten nuts no21NOTE: Apply Loctite 243 (blue) on studsAlign the seal carrier using the following tools: support plate kit (PN 529 035 506) NOTE: Use plate (PN 529 035 507) for the 155.6 mm (6-18 in) jet pumpF05I08A