Bombardier SeaDoo 2001 factory shop manual, Page 434Get this manual
Section 11 PROPULSION SYSTEM Subsection 03 (DRIVE SYSTEM)
Bearing no16 and seals no15 can be easily removed using the bearingseal remover tool (PN 295 000 144)
Excessive deflection could cause vibration and damage to drive shaft splines, impeller, flywheel or floating ring (seal carrier depending upon the model)Place drive shaft on V-blocks and set-up dial gauge in center of shaftSlowly rotate shaft; difference between highest and lowest dial gauge reading is deflectionRefer to the following illustrationMaximum permissible deflection is 0.5 mm (.020 in)
F01J11A
NOTE: The same tool is used for bearing and seals removal of jet pumpProperly support seal carrier housing no17 when removing seals and bearingAll Models
Loosen gear clamp no11 holding boot, then carefully pull boot and carbon ring no8 from hull insertF01J15A