Bombardier SeaDoo 2001 factory shop manual, Page 425Get this manual
Section 11 PROPULSION SYSTEM Subsection 02 (JET PUMP)
Check if the mechanism worked properlyPush tab with the pencil or tool; if there is small play the installation is correctIf not, redo the procedureVerify if the impeller is rotating freelyAdd oilOil Fill NOTE: It is highly recommended to perform leakage test prior adding the oilSee PUMP PRESSURIZATION in this subsectionPlace housing horizontally as in its operating position so that filler plug is located on topRemove filler plug from coverPour SEA-DOO JET PUMP SYNTHETIC OIL (PN 293 600 011) in reservoir until oil comes level with bottom of holeLet oil drain into housing and after few minutes add more oil until it is level with bottom of filler holeCAUTION: This is synthetic oilDo not mix with mineral based oilDo not mix oil brandsNOTE: When filling reservoir, oil must be poured into cover quite slowly to allow complete housing fillApply Loctite pipe sealant (PN 293 800 018) on plug threads and reinstall it on coverNOTE: The plug threads are perpendicular to the impeller shaft