Bombardier SeaDoo 2001 factory shop manual, Page 422Get this manual
Section 11 PROPULSION SYSTEM Subsection 02 (JET PUMP)
Bearing on venturi side must be to mm (.080 .157 in) inside reservoir measured from thrust washer seatRefer to following illustration
F00J0EA
F01J5YB
1Thrust bearing on top of thrust washer
1Thrust washer seat 2Stamped end of bearing A2mm (.080.157 in)
Impeller Shaft
To prevent seal lip damage when inserting impeller shaft, use impeller shaft guide (PN 295 000 002)
Thrust Washer
Position jet pump housing with the stator vanes on topInsert thrust washer no32 in the stator seat