Bombardier SeaDoo 2001 factory shop manual, Page 420Get this manual
Section 11 PROPULSION SYSTEM Subsection 02 (JET PUMP)
Impeller Side All Models Stamped end of bearings (showing identification markings) must be located toward outside of housingProperly insert bearing on toolUsing an arbor press only, push tool until tool flange contacts housing
CAUTION: These tools have been designed to properly position bearings and seal, thus providing space for lubrication purposesThe tool flanges allow thisIf different pusher type is being used, components must be properly positioned as followsBearing on impeller side must be 1.5 to 2.5 mm (.060.100 in) inside reservoir measured from seal seatRefer to following illustration