Bombardier SeaDoo 2001 factory shop manual, Page 419Get this manual
Section 11 PROPULSION SYSTEM Subsection 02 (JET PUMP)
Manually engage ring in housing making sure it is equally inserted all aroundPress ring until it seats into bottom of housing
Seal and Needle Bearing
GS and GTX RFI Models Bearings no30 and seal no29 will be properly installed in housing using bearingseal installer tool (PN 295 000 107)1
F01J4KA
F01J5DA
BEARINGSEAL INSTALLER TOOL 1Seal side 2Bearing side
1Seal lip 2Press wear ring
All Models except GS and GTX RFI Bearing no30 and seal no29 on impeller side will be properly installed in housing using bearingseal installer tool (PN 295 000 107)1
If press is not readily available, piece of wood such as in 12 in long, can be usedManually engage ring in housing making sure it is equally inserted all aroundPlace wood piece over ringUsing hammer, strike on wood to push ringStrike one side then rotate wood piece about 90 and strike againFrequently rotate wood piece so that ring slides in evenly until it seats into bottom of housing