Bombardier SeaDoo 2001 factory shop manual, Page 416Get this manual
Section 11 PROPULSION SYSTEM Subsection 02 (JET PUMP)
CLEANING
All Models Thoroughly clean jet pump housing by applying Loctite Stripper (PN 293 110 004)Allow it some time to dissolve the old dried Loctite (10 to 15 minutes)
PARTS INSPECTION
Impeller
Visually inspect impeller splinesCheck for wear or deformationRenew parts if damagedNOTE: Check also PTO flywheel and drive shaft conditionRefer to BOTTOM END and DRIVE SYSTEMExamine impeller in wear ring for distortionCheck if blade tips are blunted round, chipped or brokenSuch impeller is unbalanced and will vibrate and damage wear ring, impeller shaft, shaft seal or bearingsRenew if damagedWARNING
Technician should wear gloves when using this cleaning productCAUTION: DO NOT use Loctite Stripper on wear ring since it will cause irreparable damage to itWipe Loctite Stripper with clean clothMake sure surface is cleaned and dried of Loctite StripperSealant on the jet pump housing can be removed with wire brush (disc) mounted on drill or scraperProperly clean all threadsRemove all O-rings and clean parts in solventCarefully check water passages and oil passagesBlow low pressure compressed air through them and make sure they are clear