Bombardier SeaDoo 2001 factory shop manual, Page 374Get this manual
Section 10 ELECTRICAL SYSTEM Subsection 03 (CHARGING SYSTEM)
Clean battery terminals and cable connections using wire brushApply light coat of dielectric grease on terminalsClean battery casing and caps using solution of baking soda and waterCAUTION: Do not allow cleaning solution to enter batteryRinse battery with clear water and dry well using clean clothStore battery in cool dry placeSuch conditions reduce self-discharging and keep fluid evaporation to minimumKeep battery away from dew, high moisture and direct sunlightDuring the storage period, recheck electrolyte level and specific gravity readings at least every monthIf necessary, keep the battery at its upper level line and near full charge as possible (trickle charge)
A17E0FB
1Sealing tube removed 2Battery electrolyte 3Upper level line
Activation of New Battery WARNING
Never charge or boost battery while installed in watercraftA new battery is factory fresh dry chargedFor storage purposes, it is fitted with temporary sealing tubeCAUTION: Do not remove the sealing tube or loosen battery caps unless activation is desiredNOTE: In case of accidental premature removal of caps or sealing tube, battery should be given full chargePerform the following operations anytime new battery is to be installed1Remove the sealing tube from the vent elbow