Bombardier SeaDoo 2001 factory shop manual, Page 370Get this manual
Section 10 ELECTRICAL SYSTEM Subsection 03 (CHARGING SYSTEM)
947 Engines STATIC TEST: CONTINUITY 1Disconnect the magneto wiring harness connector2Install the 6-pin magneto harness adapter (PN 295 000 136)3Check resistance between two of the YELLOW wiresThe resistance should be between 0.1 to 1.0 ohm3 1
F01H60A
Multimeter Magneto harness adapter Positive (+) probe to YELLOW wire Negative (-) probe to ground
5Repeat test with the other two YELLOW wires of the 6-pin magneto harness adapterNOTE: There should be no continuity (infinity) between the stator insulated coils and groundIf there is reading, the stator coils andor the wiring from the coils is grounded and needs to be replaced or repairedF01H5ZA