Bombardier SeaDoo 2001 factory shop manual, Page 342Get this manual
Section 09 LUBRICATION SYSTEM Subsection 03 (OIL INJECTION PUMP)
All Engines Start and bring engine to normal operating temperatureCAUTION: If watercraft is out of water, engine must be cooled using the flush kitIf air bubbles are present in the oil injection system, bleed system before operating engineAdjust idle speed to specification on CarburetorEquipped ModelsRefer to CARBURETORNOTE: On RFI engines, refer to FUEL INJECTION for idle speed adjustment procedureNOTE: On DI engines, there is no idle speed adjustment to performStop engine
Final Synchronization
Eliminate throttle cable free-play by depressing throttle lever until slight resistance is feltIn this position, marks on pump body and lever must alignIf necessary, turn cable adjustment nut to obtain pump mark alignmentRefer to above illustrationsTighten jam nut and recheck alignment marksCAUTION: Proper oil injection pump adjustment is very importantAny delay in the opening of pump can result in serious engine damage