Bombardier SeaDoo 2001 factory shop manual, Page 306Get this manual
Section 08 FUEL SYSTEM Subsection 02 (FUEL CIRCUIT)
FUEL SYSTEM PRESSURIZATION
WARNING
Whenever doing any type of repair on watercraft or if any components of the fuel system are disconnected, pressure test must be done before starting engineEnsure to verify fuel line ends for damageAlways cut damaged end before reinstallation
Pressure Test (supply and vent circuits)
All Models Proceed as follows: Fill up fuel tank Disconnect air inlet hose of fuel tank from body Install hose pincher (PN 295 000 076) on fuel tank vent hose
Turn fuel valve to OFF position (except GTX RFI and DI) Pressurize fuel system to 34 kPa (5 PSI) If no leaks are found, turn fuel valve to ON position and pressurize once more If pressure is not maintained locate leak and repairreplace component leakingTo ease leak search spray solution of soapy water on components, bubbles will indicate leak locationNOTE: The system must maintain pressure of 34 kPa (5 PSI) during 10 minutesNever pressurize over 34 kPa (5 PSI)Reconnect air inlet hose of fuel tank to body