Bombardier SeaDoo 2001 factory shop manual, Page 273Get this manual
Section 06 ENGINE MANAGEMENT (DI) Subsection 04 (DIAGNOSTIC PROCEDURES)
NORMAL OPERATION RESUMES IF FAULT REMOVED AND
FAULT DETECTED WHILE ENGINE RUNNING
FAULT DETECTED WHILE ENGINE NOT RUNNING
DIAGNOSED COMPONENT SENSORCIRCUIT
ECU INTERNAL NAME
FAULT CODE
FAULT DETECTED
SERVICE ACTION AND POSSIBLE CAUSES
Battery voltage
BV_HI_RED
Battery voltage very high
Full resetKey off and on
Possible causes: Battery failure, rectifier failure, battery terminal connectionService action: Check fuseCheck system circuits 3-25 to batteryterminal, 2-26 to regulator pin connector pin A, 2-25 to regulator pin connector pin BPossible causes: Battery failure, rectifier failure, damaged circuit wires, battery terminal connection, damaged magneto, damaged connectorsService action: Check fuse, check system circuits 3-25 to batteryterminal, 2-26 to regulator pin connector pin A, 2-25 to regulator pin connector pin BPossible causes: Battery failure, rectifier failure, damaged circuit wires, battery terminal connection, damaged magneto, damaged connectorsService action: Check for shorts to ground or corrosion on the following system circuits 3-10 or 3-3Possible causes: Damaged circuit wires, associated sensor failure (TPI or MAP), ECU faultService action: Check for shorts to ground or corrosion on system circuit 4-18